Using Windows Explorer, copy Disk 1 of your Map 3D CD to your hard drive, to a folder path c:\Autodesk\Map3d2011
Next, if you have a second CD, copy Disk 2 of your Map 3D CD directly over the top of Disk 1, overwrite all files in your previously copied c:\Autodesk\Map3d2011 folder
Same again for Disk 3, if there is one
If you have a single self extracting exe downloaded from Autodesk
Run the exe, it will ask to unzip to a folder inside of c:\Autodesk, make a note of the folder for later use (we’ll refer to it from here as c:\Autodesk\Map3d2011), now click OK. Wait until all of the files have extracted, when they do, note that the Map 3D 2011 setup will automatically launch – make sure you close the setup and move to the next step.
Now, start the Longbow Converter tool, select the 1st tab, pick the c:\Autodesk\Map3d2011 folder, and click the Convert button.
Once the conversion process is complete, click Install/Run Setup to start setup. Next, just install as normal.
Windows 8, Windows 8.1 and Windows 10 users: Once the installation process is complete, go back to the Converter, select the 3rd tab, pick the newly installed C:\Program Files (x86)\AutoCAD Map 3d 2011 folder, then click ‘Fix’.
Now you can happily run your Map 3D 2011 32bit on Windows 7, Windows 8 and Windows 10 64bit.
Troubleshooting:
– If you are unable to activate your product, or the activation process crashes:
– If you have crashing problems using the File->Open or File->Save dialogs inside of AutoCAD please read this blog entry on the File->Open or File->Save Crash in AutoCAD
I just joined the Longbow Software team as a Software Engineer, and I have gladly offered to post some informative blogs for you all to read. Check on the left there, for all my blog entries...
Follow these instructions to solve issues around installing/running your legacy AutoCAD Mechanical 2000i on Windows 11 Ransomware Protection Windows 11 and…