Installing Sem Group Xilog Plus 1.1 on Windows 7, Windows 8 and Windows 10 64bit

It’s totally possible to install Xilog Plus on newer versions of Windows (even Windows 10 64bit) but you will need the appropriate drivers to drive your CNC

How to install Sem Group Xilog Plus

1. Obtain your purchased copy of the Longbow Reviver App here
2. Start the Reviver App and note the user interface
3. Insert your Xilog Plus CD
   1. From the “Old Installer Reviver” tab, use the ‘…’ button to pick the CD
   2. Now click the ‘Fix and Run Old Installer‘ button
      1. Follow the Reviver App instructions
      2. Once the setup appears, stop and read the next step
4. Once the setup application appears, go through the setup as normal except when you get to select the installation folder (Destination Install Folder)…
   1. You **must** change the default path to c:\xilogplus (instead of C:\Program Files\Scm Group\Xilog Plus)
   2. Also, do not run Xilog Plus at the end of the setup because an extra step is needed to fix the installed program files.
5. Once the setup is completed
   1. Make sure setup is closed down
   2. Go back to the Reviver App and wait for Success! to be displayed.
   3. In the Reviver App, pick the “Old Program Reviver” tab
   1. Using the ‘…’ button pick the path c:\xilogplus
   2. Now click ‘Fix Old Program‘
      1. When the Reviver App asks if you want to re-register, say Yes
6. Once the Reviver App displays Success! Now you can run

Copyright 2020 (c) Longbow Software