If you are seeing the message “There was a problem sending the command to the program” when you double click a DWG file from Windows Explorer, then the solution is to follow the instructions listed for your AutoCAD version below:
If you do not see your version of AutoCAD listed, or you are not an AutoCAD user, leave me a comment below and I’ll check it out for you.
Copyright Longbow Software 2015
These instructions solve issues around installing/running and the stability of your old AutoCAD Land Desktop 2009 running on 64bit Windows…
These instructions solve issues around installing/running and the stability of your old AutoCAD LT 2010 running on 64bit Windows 11.…
Follow these instructions to solve issues around installing/running your legacy AutoCAD R13 on Windows 11 Ransomware Protection Windows 11 and AutoCAD…
These instructions solve issues around installing/running and the stability of your old AutoCAD 2009 running on 64bit Windows 11. Some…
Follow the instructions on this page to install ACT! V6 (by Interact Commerce Corporation) on Windows 11. How to install…
NOTE: We currently only support US unlocked versions of 2004 on 64bit OS. European or locked US support 2004 is…
This website uses cookies.
View Comments
I have always run windows 2000 on my xp laptop. I installed autocad 2000 recently onto my windows 7 32 bit computer, without knowing about your converter. I can open the program, but windows says"do you want to allow this to alter your computer?. i click yes, then i can open a file in autocad. but then i get a notice "cant send command to program". sometimes i can proceed in the file. but on one large file, it froze after that notice came. will your converter help my situation?
You said leave a message with you.
Please contact Longbow Software support directly https://longbowsoftware.com/contact
please contact Longbow Software support and explain the issue, they can help - https://longbowsoftware.com/contact