This blog post is specifically for installing Ulead PhotoImpact 10, Ulead Photo Explorer 8.5 and Ulead COOL 360 on Windows 10, Windows 7, Windows 8 and Windows 8.1 both 32bit and 64bit (including
For instructions on installing Ulead PhotoImpact 11 on Windows 10, Windows 7, Windows 8 and Windows 8.1 click here
Installing PhotoImpact 10 on Windows 7, Windows 8 or Windows 8.1 can be very easily defined in these short steps. NOTE: Be sure to use exactly same folder paths as specified below in order to ensure a clean install.
- Obtain your copy of the Longbow Reviver here
- Using Windows Explorer, copy your PhotoImpact 10 installation CD to c:\PhotoImpact10CD
- Start the Longbow Reviver tool, select the first tab “Old Installer Reviver” tab, pick the newly copied c:\PhotoImpact10CD folder, then click the Fix and Run Old Installer button
- Once completed, read and understand all messages from the Reviver tool…
- Next, your PhotoImpact 10 setup will startup and take you through the normal install process with these exceptions..
- When asked, make sure you install PhotoImpact 10 to c:\Ulead\PhotoImpact10 (not C:\Program Files (x86)\Ulead Systems\Ulead PhotoImpact 10)
- When asked, make sure you install Photo Explorer 8.5 to c:\Ulead\PhotoExplorer85 (not C:\Program Files (x86)\Ulead Systems\Ulead Photo Explorer 8.5)
- When asked, make sure you install COOL 360 to c:\Ulead\Cool360 (not C:\Program Files (x86)\Ulead Systems\Ulead COOL 360)
- Once installed, be sure to close the PhotoImpact 10 main setup as the Reviver tool is waiting for it to close before allowing you to move to the next step.
- Finally, go back to the Reviver tool, select the 2nd tab “Old Program Reviver”, pick the newly installed c:\Ulead folder, then click “Fix Old Program“. If asked “Do you want to me to re-register your Program’s components…”, say No…
- You can now run your Ulead PhotoImpact 10, Ulead Photo Explorer 8.5 and Ulead COOL 360 Windows 10, Windows 7, Windows 8 and Windows 8.1 64bit
Copyright 2015 (c) Longbow Software