Installing AutoCAD Architecture 2010 32bit on Windows 7, Windows 8 and Windows 10

NOTE: This blog post specifically solves issues related to these error messages on installation of AutoCAD ADT 2010…

  • “This operating system is not supported by AutoCAD® Architecture”
  • “You cannot install this product on the current operating system”
  • “You are attempting to use a 32-bit installer on a 64-bit operating system”
  • “This is a 32-bit AutoCAD® Architecture® 2010. It cannot be installed on 64-bit Windows”

Installing AutoCAD Architecture 2010 32bit on Windows 7, Windows 8, Windows 8.1 or Windows 10 64bit can be very easily defined in these short steps…

NOTE: These steps do not bypass normal Autodesk licensing/authorization, you should expect to use your own serial numbers in the normal way.

  1. Obtain your copy of the Longbow Converter here
  2. If you have CDs:
    1. Using Windows Explorer, copy Disk 1 of your ADT CD to your hard drive, to a folder path c:\Autodesk\adt2010
    2. Next, if you have a second CD, copy Disk 2 of your ADT CD directly over the top of Disk 1, overwrite all files in your previously copied c:\Autodesk\adt2010 folder
    3. Same again for Disk 3, if there is one
  3. If you have a single self extracting exe downloaded from Autodesk
    1. Run the exe, it will ask to unzip to a folder inside of c:\Autodesk, make a note of the folder for later use (we’ll refer to it from here as c:\Autodesk\adt2010), now click OK. Wait until all of the files have extracted, when they do, note that the ADT 2010 setup will automatically launch – make sure you close the setup and move to the next step.
  4. Now, start the Longbow Converter tool, select the 1st tab, pick the c:\Autodesk\adt2010 folder, and click the Convert button.
  5. Once the conversion process is complete, click Install/Run Setup to start setup. Next, just install as normal.
  6. Windows 8, Windows 8.1 and Windows 10 users: Once the installation process is complete, go back to the Converter, select the 3rd tab, pick the newly installed C:\Program Files (x86)\AutoCAD Architecture 2010 folder, then click ‘Fix’.
  7. Now you can happily run your AutoCAD Architecture 2010 32bit on Windows 7, Windows 8, Windows 8.1 and Windows 10 64bit!

Troubleshooting:

– If you are unable to activate your product, or the activation process crashes:

– If you have crashing problems using the File->Open or File->Save dialogs inside of AutoCAD please read this blog entry on the File->Open or File->Save Crash in AutoCAD

Copyright 2015 (c) Longbow Software

Leave a Reply

Your email address will not be published. Required fields are marked *